This shows you the differences between two versions of the page.
|
tuto:tuto3 [2013/10/01 09:07] leoame [Move from one support to another] |
tuto:tuto3 [2013/10/01 09:17] (current) leoame [Move from one support to another] |
||
|---|---|---|---|
| Line 166: | Line 166: | ||
| {{tuto:tuto-vectorization-moveto3.png?nolink}} | {{tuto:tuto-vectorization-moveto3.png?nolink}} | ||
| - | When you are finished with the vectorization/attribution of the lines, reiterate the same operations you did with the "intensity map". At the end you shall have something looking like this: | + | When you are finished with the vectorization/attribution of the lines, reiterate the operations of the chapter "[[tuto:tuto3#drawing_the_labels|Drawing the labels]]". At the end you shall have something looking like this: |
| {{tuto:tuto-vectorization-moveto4.png?nolink}} | {{tuto:tuto-vectorization-moveto4.png?nolink}} | ||
| - | ===== Go on ===== | + | ===== Move on ===== |
| - | You can continue to draw all the information you want with this process. The polygonal layers regroup both the process for the lines and the points layer. So now you shall be able to proceed with all the remaining information (in the practical case just the line layer Instability_structures). | + | There is still the last layer to vectorize and attribute, the instability structures. As it is a line layer you just have to follow the process of the chapter "[[tuto:tuto3#drawing_the_lines|Drawing the lines]]". |
| + | |||
| + | Hint: No vectorization should be required ;) | ||
| <WRAP 75%><note tip> | <WRAP 75%><note tip> | ||